Tune your Heat Factor, Compression Factor, and Cooling Factor
Enter values into CANVAS/Chroma
Step 1: Choose Baseline Splice Numbers
Step 2: Use Splice Tuning Mode on Palette 2
Step 3: Tune your Heat, Compression and Cooling Values
Heat & Cooling Factor
Bulging splices - If a splice is too hot when it begins to move, it can cause a bulge. The front of the filament is pulled, but the splice does not move enough, and the back filament compresses into the splice. To address this, either (1) if possible, lower the Compression Factor, or (2) slightly increase the Cooling Factor so the splice has more time to solidify.
Compression Factor
Step 4a: Enter values into CANVAS To use the Heat, Compression, and Cooling Factors found during splice tuning, open your project select a color swatch or input drive.
